Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

Example of the protocol lldp Command (CONFIGURATION Level)

Dell(conf)#protocol lldp
                                 Dell(conf-lldp)#?
                                 advertise        Advertise TLVs
                                 disable          Disable LLDP protocol globally
                                 end              Exit from configuration mode
                                 exit             Exit from LLDP configuration mode
                                 hello            LLDP hello configuration
                                 mode             LLDP mode configuration (default = rx and tx)
                                 multiplier       LLDP multiplier configuration
                                 no               Negate a command or set its defaults
                                 show             Show LLDP configuration
                                 
                                 
                                 Dell(conf-lldp)#exit
                                 Dell(conf)#interface tengigabitethernet 0/3
                                 Dell(conf-if-te-0/3)#protocol lldp
                                 Dell(conf-if-te-0/3-lldp)#?
                                 advertise        Advertise TLVs
                                 disable          Disable LLDP protocol on this interface
                                 end              Exit from configuration mode
                                 exit             Exit from LLDP configuration mode
                                 hello            LLDP hello configuration
                                 mode             LLDP mode configuration (default = rx and tx)
                                 multiplier       LLDP multiplier configuration
                                 no               Negate a command or set its defaults
                                 show             Show LLDP configuration
                                 Dell(conf-if-te-0/3-lldp)#