Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configure Route Map Filters

Within ROUTE-MAP mode, there are match and set commands.

  • match commands search for a certain criterion in the routes.
  • set commands change the characteristics of routes, either adding something or specifying a level.

When there are multiple match commands with the same parameter under one instance of route-map, the system does a match between all of those match commands. If there are multiple match commands with different parameters, the system does a match ONLY if there is a match among ALL the match commands.

In the following example, there is a match if a route has any of the tag values specified in the match commands.

Example of the match Command to Match Any of Several Values 

Dell(conf)#route-map force permit 10
                                 Dell(config-route-map)#match tag 1000
                                 Dell(config-route-map)#match tag 2000
                                 Dell(config-route-map)#match tag 3000

In the next example, there is a match only if a route has both of the specified characteristics. In this example, there a match only if the route has a tag value of 1000 and a metric value of 2000.

Also, if there are different instances of the same route-map, then it’s sufficient if a permit match happens in any instance of that route-map. 

Dell(conf)#route-map force permit 10
                                 Dell(config-route-map)#match tag 1000
                                 Dell(config-route-map)#match metric 2000

In the following example, instance 10 permits the route having a tag value of 1000 and instances 20 and 30 deny the route having a tag value of 1000. In this scenario, the system scans all the instances of the route-map for any permit statement. If there is a match anywhere, the route is permitted. However, other instances of the route-map deny it.

Example of the match Command to Permit and Deny Routes 

Dell(conf)#route-map force permit 10
                                 Dell(config-route-map)#match tag 1000
                                 
                                 Dell(conf)#route-map force deny 20
                                 Dell(config-route-map)#match tag 1000
                                 
                                 Dell(conf)#route-map force deny 30
                                 Dell(config-route-map)#match tag 1000

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"