Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Important Points to Remember

  • Port monitoring is supported on physical ports only; virtual local area network (VLAN) and port-channel interfaces do not support port monitoring.
  • The monitored (the source, [MD]) and monitoring ports (the destination, [MG]) must be on the same switch.
  • The monitored (source) interface must be a server-facing interface in the format slot/port, where the valid slot numbers are 0 and server-facing port numbers are from 1 to 8.
  • The destination interface must be an uplink port (ports 9 to 12).
  • In general, a monitoring port should have no ip address and no shutdown as the only configuration; the Dell Networking OS permits a limited set of commands for monitoring ports. You can display these commands using the ? command.
  • A monitoring port may not be a member of a VLAN.
  • There may only be one destination port in a monitoring session.
  • A source port (MD) can only be monitored by one destination port (MG). If you try to assign a monitored port to more than one monitoring port, the following message displays: 
    Dell(conf)#mon ses 1
                                       Dell(conf-mon-sess-1)#source tengig 0/1 destination tengig 0/8 direction both
                                       Dell(conf-mon-sess-1)#do show monitor session
                                       
                                       SessionID   Source       Destination   Direction    Mode       Type
                                       ---------   ------       -----------   ---------    ----        ----
                                       1    TenGig 0/1    TenGig 0/8   both        interface   Port-based
                                       
                                       Dell(conf-mon-sess-1)#mon ses 2
                                       Dell(conf-mon-sess-2)#source tengig 0/1 destination tengig 0/8 direction both
                                       % Error: MD port is already being monitored.
  • NOTE: There is no limit to the number of monitoring sessions per system, provided that there are only four destination ports per port-pipe. If each monitoring session has a unique destination port, the maximum number of session is four per port-pipe.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"