Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To enable VRRP, create a virtual router. In Dell, the virtual router identifier (VRID) identifies a VRRP group.

• Create a virtual router for that interface with a VRID. INTERFACE mode vrrp-group vrid The VRID range is from 1 to 255.
  • NOTE: The interface must already have a primary IP address defined and be enabled, as shown in the second example.
• Delete a VRRP group. INTERFACE mode no vrrp-group vrid

Dell(conf)#int tengig 1/1
                                 Dell(conf-if-te-1/1)#
                                 vrrp-group 111
                                 Dell(conf-if-te-1/1-vrid-111)#
                              

Dell(conf-if-te-1/1)#show conf
                                 !
                                 interface Tengigabitethernet 1/1
                                 
                                 ip address 10.10.10.1/24
                                 !
                                 vrrp-group 111
                                 
                                 no shutdown
                                 Dell(conf-if-te-1/1)#