Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To configure a VLT interconnect, follow these steps.

1. Configure the port channel for the VLT interconnect on a VLT switch and enter interface configuration mode. CONFIGURATION mode interface port-channel id-number Enter the same port-channel number configured with the peer-link port-channel command as described in Configuring VLT and Connecting a VLT Domain .
   • NOTE: To be included in the VLTi, the port channel must be in Default mode ( no switchport or VLAN assigned).
2. Remove an IP address from the interface. INTERFACE PORT-CHANNEL mode no ip address
3. Add one or more port interfaces to the port channel. INTERFACE PORT-CHANNEL mode channel-member interface interface : specify one of the following interface types:
   • 10-Gigabit Ethernet: Enter tengigabitethernet slot/port .
4. Ensure that the port channel is active. INTERFACE PORT-CHANNEL mode no shutdown
5. Repeat Steps 1 to 4 on the VLT peer switch to configure the VLT interconnect.