Dell Lifecycle Controller GUI v2.30.30.30 User's Guide

Configuring iDRAC

To configure iDRAC parameters applicable to the system, such as LAN, common IP settings, IPv4, IPv6, Virtual Media, and LAN user configuration use the iDRAC Settings wizard.

NOTE: You can also use the System Setup utility during startup for configuring iDRAC. For more information about the System Setup utility, see Using The System Setup Program And Boot Manager.

To configure and manage the iDRAC parameters:

Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
In the left pane of Home page, click Hardware Configuration.
In the right pane, click Configuration Wizards.
On the System Configuration Wizards page, click iDRAC Settings, and then click the following options to configure the different iDRAC parameters. For more information about configuring iDRAC settings, see the Integrated Dell Remote Access Controller (iDRAC) User’s Guide at dell.com/esmmanuals.
- NOTE: Click System Summary to view the parameters and their values.
- Network
- OS to iDRAC Pass Through
- Alerts
- System Event Log
- Virtual Media
- vFlash Media
- Thermal
- System Location
- Front Panel Security
- User Configuration
- Smart Card
- Lifecycle Controller
- Remote Enablement
- Reset iDRAC Configuration to defaults
Click Back after setting the parameters for each option to return to the main menu.
Click Finish to apply the changes.