Μετάβαση στο κύριο περιεχόμενο
Έξοδος

Καλώς ορίσατε στην Dell

Ο λογαριασμός μου
  • Υποβάλετε παραγγελίες γρήγορα και εύκολα
  • Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
  • Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Είσοδος Δημιουργήστε έναν λογαριασμό Είσοδος στο Premier Είσοδος στο Πρόγραμμα συνεργατών
Επικοινωνία

Dell Wyse ThinOS Release 8.3.1 Administrator’s Guide

PDF

Configuring the Dual Head Display Settings

To configure the Dual head display settings:
  1. From the desktop menu, click System Setup, and then click Display. The Display dialog box is displayed.
  2. Click Dual Head tab, and use the following guidelines: This feature is applicable for supported Dual Monitor Capable Thin Clients Only.
    1. Dual Head—Select Mirror Mode to have the two monitors work in a matching state, or Span Mode to have the two monitors work separately second is extended from first.
    2. Main Screen—Select which of the two monitors you want to be the main screen ( Screen1 or Screen2). The other screen is extended from the main screen.

      The other screen is extended from the main screen. When using a DVI to DVI/VGA splitter with VGA and DVI monitors at the same time, the VGA monitor will be the primary monitor.

    3. Layout—Select how you want the two monitors to be oriented to each other.

      Horizontal — where you move between the monitors from the left and right of the screens.

      Vertical— where you move between the monitors from the top and bottom of the screens.

    4. Alignment— Select how you want the monitors to be aligned Bottom, Center, or Top.

      Bottom means screens are bottom-aligned in a horizontal orientation; Center means screens are center-aligned; Top means screens are top-aligned in a horizontal orientation.

    5. Taskbar (Classic Desktop Only)—Select under which screen you want the Taskbar to appear Whole Screen or Main Screen

      Gamma Supported Monitors Only— Use the Gamma Setup tab to adjust the saturation values for Red, Green and Blue on VGA connected monitors supporting gamma settings, if you feel the default settings are too light. Be aware that the Gamma Setup tab will be disabled once you click Save+Exit. You can enable it again by setting rgamma={1-100} ggamma={1-100} bgamma={1-100} in the Resolution INI parameter. For more information, see Dell Wyse ThinOS INI Guide .

      For Swap dual screens, when you set Main Screen to Screen2, an additional check box is displayed at the bottom of the tab that allows you to swap dual screens. If you clear the check box, the Screen1 is usually the left one or the top one in dual display. When you set Main Screen to Screen2, the main screen is changed to the right screen or bottom screen. If you select the swap dual screens check box, you are able to set Main Screen to Screen2, but still have it at the left side or the top side, which is considered more user friendly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\