Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

clear counters

Clear the counters used in the show interfaces commands for VLANs, and physical interfaces, or selected ones.

Syntax

clear counters interface

Defaults

Without a specific interface specified, the command clears all interface counters.

Parameters

interface

(OPTIONAL) Enter any of the following keywords and slot/port or number to clear counters from a specified interface:

For the management interface on the stack-unit, enter the keyword managementethernet followed by slot/port information. The slot and port range is 0.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information.
For a Port Channel interface, enter the keyword port-channel followed by a number. Range: 1-128

NOTE: This command also enables you to clear the port configurations corresponding to a range of ports.
- You can specify multiple ports as slot/port-range. For example, if you want to clear the port configurations corresponding to all ports between 1 and 4, specify the port range as show interfaces interface-type 1/1 - 4.

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM and added support to clear the interface configurations corresponding to a range of ports.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Example

Dell#clear counters
                                             Clear counters on all interfaces [confirm]