Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

interface loopback

Configure a Loopback interface.

Syntax

interface loopback number

To remove a loopback interface, use the no interface loopback number command.

Parameters

number

Enter a number as the interface number. The range is from 0 to 16383.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell(conf)#interface loopback 1655
                                             Dell(conf-if-lo-1655)#

Related Commands

interface — configures a physical interface.

interface null — configures a Null interface.

interface port-channel — configures a port channel.

interface vlan — configures a VLAN.