Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show config

Display the changes you made to the IS-IS configuration. Default values are not shown.

Syntax show config
Command Modes
  • ROUTER ISIS ( for IPv4)
  • CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 ( for IPv6)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example (Router-Isis)

The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode. 

Dell(conf-router_isis)#show config
                                             !
                                             router isis
                                             clns host ISIS 49.0000.0001.F100.E120.0013.00
                                             log-adjacency-changes
                                             net 49.0000.0001.F100.E120.0013.00
                                             !
                                             address-family ipv6 unicast
                                             maximum-paths 16
                                             
                                             multi-topology transition
                                             set-overload-bit
                                             spf-interval level-1 100 15 20
                                             spf-interval level-2 120 20 25
                                             exit-address-family
Example (Address-Family_IPv6)

The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode. 

Dell(conf-router_isis-af_ipv6)#show conf
                                             !
                                             address-family ipv6 unicast
                                             maximum-paths 16
                                             
                                             multi-topology transition
                                             set-overload-bit
                                             spf-interval level-1 100 15 20
                                             spf-interval level-2 120 20 25
                                             exit-address-family

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\