Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip ospf

Display information on the OSPF process configured on the switch.

Syntax

show ip ospf process-id

Parameters

process-id

Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process.

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area 0.

The following describes the show ip ospf command shown in the following example.

Line Beginning with	Description
“Routing Process...”	Displays the OSPF process ID and the IP address associated with the process ID.
“Supports only...”	Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...”	Displays the delay and hold time configured for this process ID.
“Convergence Level”
“Min LSA....”	Displays the intervals set for LSA transmission and acceptance.
“Number of...”	Displays the number and type of areas configured for this process ID.

Example

Dell#show ip ospf 10
                                             Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-vrf
                                             Supports only single TOS (TOS0) routes
                                             SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
                                             Convergence Level 0
                                             Min LSA origination 0 msec, Min LSA arrival 1000 msec
                                             Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
                                             Number of area in this router is 1, normal 1 stub 0 nssa 0
                                             Area BACKBONE (0)
                                             Number of interface in this area is 1
                                             SPF algorithm executed 205 times
                                             Area ranges are
                                             Dell#

Related Commands

show ip ospf database — displays information about the OSPF routes configured.

show ip ospf interface — displays the OSPF interfaces configured.

show ip ospf neighbor — displays the OSPF neighbors configured.