Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

IGMP Commands

The Dell Networking OS supports the following IGMP commands:

Important Points to Remember

  • Dell Networking OS supports version 1, version 2, and version 3 hosts.
  • Dell Networking OS IGMP snooping implementation is based on IP multicast address (not based on Layer 2 multicast mac-address) and the IGMP snooping entries are in Layer 3 flow table not in Layer 2 forwarding information base (FIB).
  • Dell Networking OS IGMP snooping implementation is based on draft-ietf-magma-snoop-10.
  • IGMP snooping is enabled by default on the switch.
  • A maximum of 2k groups and 4k virtual local area networks (VLAN) are supported.
  • IGMP snooping is not supported on default VLAN interface.
  • Flooding of unregistered multicast traffic is enabled by default.
  • Queries are not accepted from the server side ports and are only accepted from the uplink LAG.
  • Reports and Leaves are flooded by default to the uplink LAG irrespective of whether it is an mrouter port or not.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\