Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor peer-group (assigning peers)

Allows you to assign one peer to a existing peer group.

Syntax

neighbor ipv6-address peer-group peer-group-name

To delete a peer from a peer group, use the no neighbor ipv6-address peer-group peer-group-name command.

Parameters

ipv6-address	Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group peer-group-name	Enter the keywords `peer-group` then the name of a configured peer group (maximum 16 characters).

Defaults

Not configured.

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

You can assign up to 64 peers to one peer group.

When you add a peer to a peer group, it inherits all the peer group’s configured parameters. A peer cannot become part of a peer group if any of the following commands are configured on the peer:

A neighbor may keep its configuration after it was added to a peer group if the neighbor’s configuration is more specific than the peer group’s and the neighbor’s configuration does not affect outgoing updates.

A peer group must exist before you add a peer to it. If the peer group is disabled ( shutdown) the peers within the group are also disabled ( shutdown).

Related Commands

capture bgp-pdu max-buffer-size — resets BGP sessions.

neighbor peer-group (creating group) — creates a peer group.

show ip bgp ipv6 unicast peer-group — views BGP peers.

show ip bgp ipv6 unicast neighbors — views BGP neighbors configurations.