Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug vrrp

Allows you to enable debugging of VRRP.

Syntax

debug vrrp interface [ vrrp-id] {all | packets | state | timer}

To disable debugging, use the no debug vrrp interface [ vrrp-id] {all | packets | state | timer} command.

Parameters

interface	Enter the following keywords and slot/port or number information For Port Channel interface types, enter the keywords `port-channel` then the number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information. For a VLAN interface, enter the keyword `vlan` then the VLAN ID. The VLAN ID range is from 1 to 4094.
vrrp-id	(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all	Enter the keyword `all` to enable debugging of all VRRP groups.
packets	Enter the keyword `packets` to enable debugging of VRRP control packets.
state	Enter the keyword `state` to enable debugging of VRRP state changes.
timer	Enter the keyword `timer` to enable debugging of the VRRP timer.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If you do not specify options, debug is active on all interfaces and all VRRP groups.