Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

sflow ingress-enable

Enable sFlow ingress on interfaces.

Syntax sflow ingress-enable

To disable sFlow, use the no sflow ingress enable command.

Defaults Disabled.
Command Modes INTERFACE
Supported Modes Full–Switch Mode
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any incoming traffic.
  • NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG port.
Related Commands sflow enable (Global) — turns sFlow globally.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\