Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip pim sparse-mode sg-expiry-timer

Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs an access list defines.

Syntax

ip pim sparse-mode sg-expiry-timer seconds [access-list name]

To disable configured timers and return to default mode, use the no ip pim sparse-mode sg-expiry-timer command.

Parameters

seconds	Enter the number of seconds the S, G entries are retained. The range is from 211 to 86400.
access-list name	(OPTIONAL) Enter the name of a previously configured Extended ACL to enable the expiry time to specified S,G entries.

Defaults

Disabled. The default expiry timer (with no times configured) is 210 sec.

Command Modes

CONFIGURATION

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command configures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL.