Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

snmp-server enable traps

Enable SNMP traps.

Syntax

snmp-server enable traps [ notification-type] [ notification-option]

To disable traps, use the no snmp-server enable traps [ notification-type] [ notification-option] command.

Parameters

notification-type

Enter the type of notification from the following list:

ecfm — Notification of changes to ECFM.
entity — Notification of changes to entity.
envmon — For Dell Networking device notifications when an environmental threshold is exceeded.
eoam — Notification of changes to the EOAM state.
ets — Notification of changes to the ets traps.
fips — Notification of changes to the FIP snooping state.
lacp — Notification of changes.
pfc — Notification of changes to pfc traps.
snmp — Notification of RFC 1157 traps.
stp — Notification of a state change in the spanning tree protocol (RFC 1493).
vrrp — Notification of a state change in a VRRP group.
xstp — Notification of a state change in MSTP (802.1s), RSTP (802.1w), and PVST+.

notification-option

For the envmon notification-type, enter one of the following optional parameters:

temperature

For the snmp notification-type, enter one of the following optional parameters:

authentication
coldstart
linkdown
linkup
syslog-reachable
syslog-unreachable

Defaults

Not enabled.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch Mode

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.8(0.0)	Added the following two SNMP notification options: `syslog-reachable` and `syslog-unreachable`.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The system supports up to 16 SNMP trap receivers.

If you do not configure this command, no traps controlled by this command are sent. If you do not specify a notification-type and notification-option, all traps are enabled.

Related Commands

snmp-server community — enables SNMP and sets the community string.