Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 address eui64

Configure IPv6 EUI64 address configuration on the interface.

Syntax

ipv6 address { ipv6-address prefix-length} eui64

To disable IPv6 EUI64 address autoconfiguration, use the no ipv6 address { ipv6-address prefix-length} eui64 command.

Parameters

ipv6-address prefix-length

Enter the IPv6 prefix in the x:x:x:x::x format then the prefix length in the /x format. The range is from /0 to /128.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This command allows you to create an EUI64 address based on the specified prefix and MAC address only. Prefixes may be configured on the interface using the ipv6 nd prefix command without creating an EUI64 address.

Example

Dell(conf)#int ten 0/4
                                             Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
                                             Dell(conf)#int ten 0/6
                                             Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64