Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip udp-broadcast-address

Configure an IP UDP address for broadcast.

Syntax ip udp-broadcast-address address

To delete the configuration, use the no ip udp-broadcast-address address command.

Parameters
address Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes INTERFACE (config-if)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Usage Information When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is configured using this command, the outgoing packet’s IP destination address is replaced with the configured broadcast address.
Related Commands

debug ip udp-helper — enables debug and displays the debug information on a console.

show ip udp-helper — displays the configured UDP helpers on all interfaces.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\