Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show protocol-tunnel

Display protocol tunnel information for all or a specified VLAN-Stack VLAN.

Syntax

show protocol-tunnel [vlan vlan-id]

Parameters

vlan vlan-id

(OPTIONAL) Enter the keyword vlan then the VLAN ID to display information for the one VLAN. The range is from 1 to 4094.

Defaults

none

Command Modes

EXEC

Supported Modes

Full–Switch Mode

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell#show protocol-tunnel
                                             System Rate-Limit: 75 frames/second
                                             VLAN  Protocols   Interface
                                             1000  STP,PVST    Te 5/7,Te 5/6
                                             1001  LLDP,GVRP   Te 5/7,Te 5/6
                                             1002  MMRP,MVRP   Te 5/7,Te 5/6
                                             1003  LACP,DOT1X  Te 5/7,Te 5/6
                                             1004  OAM,PAUSE   Te 5/7,Te 5/6
                                             1005  E-LMI       Te 5/7,Te 5/6

Example (Specific VLAN)

Dell#show protocol-tunnel vlan 2
                                             System Rate-Limit: 1000 Frames/second
                                             Interface  Vlan  Protocol(s)
                                             Te1/2      2     STP, PVST
                                             Dell#

Related Commands

show running-config — displays the current configuration.