Assigning a
system setup password
To enter the
system setup, press F2 immediately after a power-on or re-boot.
- In the System BIOS or System Setup screen, select Passwords on the left pane.
The Passwords screen
is displayed.
- In the System Password or the Admin Password section, create a password in the Enter the new password field, and then press Enter.
Use the following guidelines to assign the system
password:
- A password can have up to 32 characters.
- The password can contain the numbers 0 through 9.
- Only lower case letters are valid, upper case letters
are not allowed.
- Only the following special characters are allowed:
space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
- Re-enter the password and press Enter to confirm.
- Press Esc and a message prompts you to save
the changes.
- Press Y to save the changes.
The computer reboots.
Data is not available for the Topic