Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Latitude 5501 Service Manual

Installing the DC-in

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the DC-in and provides a visual representation of the installation procedure.

Installing the DC-in

Steps

  1. Locate the DC-in slot on your computer.
  2. Insert the DC-in port into the slot on your computer.
  3. Connect the DC-in cable to the system board.
  4. Place the DC-in and USB Type-C metal bracket on the DC-in port.
  5. Install the two screws (M2x5) that secures the DC-in and USB Type-C metal bracket to the system board.

Next steps

  1. Install the heat sink (for discrete only).
  2. Install the battery.
  3. Install the base cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\