- Notes, cautions, and warnings
- Working on Your Computer
- Removing and
Installing Components
- Removing the Battery
- Installing the Battery
- Removing the hard drive
- Installing the Hard Drive
- Removing the optical drive
- Installing the Optical Drive
- Removing the optical drive connector
- Installing the Optical Drive Connector
- Removing the Bottom Cover
- Installing the Bottom Cover
- Removing the Keyboard
- Installing the Keyboard
- Removing the Memory Module
- Installing the Memory Module
- Removing the Docking Board
- Installing the Docking Board
- Removing the GPU Board
- Installing the GPU Board
- Removing the SIM Module
- Installing the SIM Module
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the WWAN Card
- Installing the WWAN Card
- Removing the GPS Holder
- Installing the GPS Holder
- Removing the Heatsink
- Installing the Heatsink
- Removing the System Fan
- Installing the System Fan
- Removing the RF Holder
- Installing the RF Holder
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the I/O Board
- Installing the I/O Board
- Removing the Storage Connector
- Installing the Storage Connector
- Removing the SSD Bracket
- Installing the SSD Bracket
- Removing the USH Board
- Installing the USH Board
- Removing the Driving Board
- Installing the Driving Board
- Removing the Battery Connector
- Installing the Battery Connector
- Removing the System Board
- Installing the System Board
- System Setup
- Diagnostics
- Specifications
- Contacting Dell
Dell Latitude 14 Rugged — 5404 Series Owner's Manual
Installing the System Fan
- Place the system fan into its place on the computer.
- Tighten the screw that secures the system fan to the computer
- Connect the system fan cable to the computer.
- Route the system fan cable.
- Install:
- Follow the procedures in After Working Inside Your computer
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\