Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 5000 Small Form Factor Service Manual

PDF

Installing the power-supply unit

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power-supply unit and provides a visual representation of the installation procedure.

PSU install step 3image

Steps

  1. Place and align the screw holes on the power-supply unit to the screw holes on the chassis.
  2. Replace the three (M6-32) screws to secure the power-supply unit to the chassis.
  3. Route the power-supply cables through the routing guides on the chassis.
  4. Connect the power-supply cables to the connectors on the system board.

Next steps

  1. Install the disk-drive cage.
  2. Install the 3.5-inch hard-drive.
  3. Install the 2.5-inch hard-drive.
  4. Install the front bezel.
  5. Install the side cover.
  6. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\