Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 5000 Small Form Factor Service Manual

PDF

Installing the power button

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the power button and provide a visual representation of the installation procedure.

image of installing the power button

Steps

  1. Insert the power button and its cable into the slot on the chassis.
  2. Press the power button until it is seated on the slot on the chassis.
  3. Connect the power-button cable to the connector on the system board.

Next steps

  1. Install the disk-drive cage.
  2. Install the 3.5-inch hard-drive.
  3. Install the 2.5-inch hard-drive.
  4. Install the front bezel.
  5. Install the side cover.
  6. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\