OptiPlex 5000 Small Form Factor Service Manual

PDF

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.

NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.

NOTE:Screw color may vary with the configuration ordered.

Table 1. Screw listThe following table provides the different screws that are used in your OptiPlex 5000 Small Form Factor.
Component	Screw type	Quantity	Screw image
Solid-state drive	M2x3	1
Hard-drive and optical-drive supporting bracket	#6-32	2
SD-card reader	M3x5	1
WLAN card	M2x3	1
WLAN antenna	M3x3	2
Fan assembly	M3	3
Processor heat-sink assembly	Captive	4
Voltage-regulator heat-sink	Captive	4
Power-supply unit	#6-32	3
Optional I/O module (VGA/HDMI/DP/USB Type-C)	M3x3	2
Front I/O bracket	#6-32	1
System board	#6-32	4