Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

OptiPlex 5000 Small Form Factor Service Manual

Installing the 2.5-inch hard drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the 2.5-inch hard drive and provide a visual representation of the installation procedure.

NOTE:For systems that support dual 2.5-inch hard drives, the second 2.5-inch hard drive can be mounted to the back of the hard-driver carrier. The installation steps remain the same for both hard-drives.

image of installing the 2.5-icnh HDD assembly

image of installing the 2.5-icnh HDD assembly

Steps

  1. Align the slots on the 2.5-inch hard drive with the mounting points on the hard-drive carrier.
  2. Pry the hard-drive carrier to align the mounting points on the hard-drive carrier with the slots on the 2.5-inch hard drive.
  3. Snap the 2.5-inch hard drive onto the hard-drive carrier.
  4. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier onto the disk-drive cage.
    NOTE:Use the arrows seen on the caddy as guides to identify the tabs on the tray.
  5. Connect the hard-drive data and power cables to the connectors on the hard drive.

Next steps

  1. Install the front bezel.
  2. Install the side cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\