Use the Touch Screen tab to configure touch screens
that are connected to the thin client. The tab is available when the thin client detects that a touch screen
is attached through a USB port or a serial port, and the setup or calibration has not
been performed. The Touch Setup window prompts you to touch two circles
on the screen to make the necessary calibration adjustment. The adjusted
calibrated values are saved in the local terminal NVRAM until the
system is reset to factory default, or another type of touch display
is connected.
Touch screen is an optional configuration for the Wyse 5470 Thin Client. It is recommended to use the default 1920 x 1080 resolution. If you use a custom resolution, the touch screen does not calibrate accurately.
Table 1. Single and multi touch supportSingle touch and multi touch support
Local and VDI sessions
Single touch
Multi touch
ThinOS local
Supported
Not applicable
RDP
Supported
Supported—both desktop and application
ICA
Supported
Not Supported
Blast
Supported
Not Supported
PCoIP
Supported
Not Supported
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\