Installing the
display assembly
- Insert the display hinges into the slots on
the computer.
NOTE: This should be done with the display assembly in open position. Ensure
that the cables are free from the hinge slots and computer.
- Close the display assembly.
- Insert the WLAN and WWAN cables through the
slot on the computer
- Route the display assembly cable through the
slot and routing clips on the computer.
- Tighten the screws to secure the display assembly
to the computer.
- Route the WLAN and WWAN cables through the
routing channel on the system board.
- Connect the WLAN and WWAN cables to the connectors
on the WLAN and WWAN cards.
- Connect the display cable to the connector
on the system board.
- Place the display cable bracket over the connector
and tighten the screws to secure the display
cable to the system board.
- Tighten the screws to secure the display assembly
to the computer.
- Install the display hinge brackets and tighten
the screws to secure it to the computer.
- Install the:
- WLAN card
- WWAN card
- battery
- base cover
- Follow the procedure in After working inside
your computer.
Data is not available for the Topic