Installing the
display panel
- To install the display panel for non touch
systems:
- Connect the eDP cable to the connector
on the back of the display panel and fix the adhesive tape.
- Align the display panel with the tabs on
the display assembly.
- Tighten the screws to secure the display
panel to the display assembly.
- To install the display panel for touch systems:
- Place the display panel facedown.
- Place the display assembly over the display panel and
slide it forward.
- Connect the eDP cable to the connector
on the back of the display panel and fix the adhesive tape.
- Turn the display assembly over.
- Align the display panel with the tabs on
the display assembly.
- Press the edges of the display panel to
secure it to the display assembly.
- Install the:
- display bezel
NOTE: This is applicable only for non touch systems.
- display assembly
- battery
- base cover
- Follow the procedure in After working inside
your system.
Data is not available for the Topic