Removing the
display panel
- Follow the procedure in Before working inside
your computer.
- Remove the:
- base cover
- battery
- display assembly
- display bezel
NOTE: This is applicable only for non touch systems.
- To remove the display panel for non touch
systems:
- Remove the screws that secure the display
panel to the display assembly [1].
- Lift the display panel and turn the display
panel over to access the eDP cable [2].
- Peel the adhesive [3] to access the eDP
cable.
- Disconnect the eDP cable from the connector
[4, 5, 6].
- Lift the display panel.
- To remove the display panel for touch systems:
- Using a plastic scribe lift the edges of
the display panel to disengage it from the display assembly.
- Place the display panel facedown.
- Slide the display assembly to access the
eDP cable.
- Peel the adhesive to access the eDP cable
[1].
- Disconnect the eDP cable from the connector
on the back of the display panel [2, 3].
- Lift the display assembly from the display
pane [4].
Data is not available for the Topic