Allows you to enable or disable the computer from
turning on automatically when an AC adapter is connected.
Default setting: Wake on AC is not selected.
Auto On Time
Allows you to set the time at which the computer must
turn on automatically. The options are:
Disabled
Every Day
Weekdays
Select Days
Default setting: Disabled
USB Wake Support
Allows you to enable USB devices to wake the system
from Standby.
NOTE: This feature is only functional when the AC power adapter is connected.
If the AC power adapter is removed during Standby, the system setup removes
power from all the USB ports to conserve battery power.
Enable USB Wake Support
Default setting: The option is disabled.
Wireless Radio Control
Allows you to enable or disable the feature that automatically
switches from wired or wireless networks without depending on the
physical connection.
Control WLAN Radio
Control WWAN Radio
Default setting: The option is disabled.
Wake on LAN/WLAN
Allows you to enable or disable the feature that powers
on the computer from the Off state when triggered by a LAN signal.
Disabled
LAN Only
WLAN Only
LAN or WLAN
Default setting: Disabled
Block Sleep
This option lets you block entering to sleep (S3 state)
in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Peak Shift
This option enables you to minimize the AC power consumption
during the peak power times of day. After you enable this option,
your system runs only in battery even if the AC is attached.
Dock Support on Battery
This option allows you to use the docking station
when AC power is absent but only when the battery is above a certain
charge percentage. The percentage may change per battery and per platform.
Dock Support on Battery
Default setting: Disabled
Advanced Battery Charge Configuration
This option enables you to maximize the battery health.
By enabling this option, your system uses the standard charging algorithm
and other techniques, during the non-work hours to improve the battery
health.
Disabled
Default setting:
Disabled
Primary Battery Charge Configuration
Allows you to select the charging mode for the battery.
The options are:
Adaptive
Standard — Fully charges your battery at a standard
rate.
ExpressCharge — The battery charges over a shorter period
of time using Dell’s fast charging technology. This option is enabled
by default.
Primarily AC use
Custom
If Custom Charge is selected, you can also configure
Custom Charge Start and Custom Charge Stop.
NOTE: All charging mode may
not be available for all the batteries. To enable this option, disable
the Advanced Battery Charge Configuration option.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\