Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

Source IP address

Configure one interface IP address to include in all NTP packets. The source address of NTP packets is the interface IP address the system uses to reach the network by default.

  • Configure a source IP address for NTP packets in CONFIGURATION mode. 
    ntp source interface
    • ethernet node/slot/port[:subport]—Enter the Ethernet interface information.
    • port-channel channel-id—Enter the port-channel ID, from 1 to 128.
    • vlan vlan-id—Enter the VLAN ID number, from 1 to 4093.
    • loopback id—Enter the Loopback interface ID number, from 0 to 16383.
    • mgmt node/slot/port—Enter the physical port interface for the Management interface. The default is 1/1/1.

Configure the source IP address 

OS10(config)# ntp source ethernet 1/1/10

View the source IP configuration 

OS10(config)# do show running-configuration | grep source
ntp source ethernet1/1/1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\