Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

Configure VRRP Active-Active mode

To enable optimized L3 forwarding over VLT, use VRRP Active-Active mode. By default, VRRP Active-Active mode is enabled on the VLAN interfaces. In this mode, each peer locally forwards L3 traffic, eliminating traffic flow across the VLTi link. Configure the same static and dynamic L3 routing on each peer to ensure that L3 reachability and routing tables are the same on both peers.

  1. Enable VRRP Active-Active mode in VLAN-INTERFACE mode.
    vrrp mode active-active
  2. Configure VRRP on the L3 VLAN that spans both peers.
  3. Repeat the steps on the VLT peer.

Configure VRRP active-active mode — peer 1

OS10(conf-if-vl-10)# vrrp mode active-active
NOTE: VRRP active-active is the default mode.

Configure VRRP active-active mode — peer 2

OS10(conf-if-vl-10)# vrrp mode active-active

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\