Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

client-to-client

Enables route reflection between clients in a cluster.

Syntax
client-to-client {reflection}
Parameters
reflection — Enter to enable reflection of routes allowed in a cluster.
Default
Enabled
Command Mode
ROUTER-BGP
Usage Information
Configure the route reflector to enable route reflection between all clients. You must fully mesh all clients before you disable route reflection. The no version of this command disables route reflection in a cluster.
NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands:
  1. Enter the ROUTER BGP mode using the router bgp as-number command.
  2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command.
Example 
OS10(conf-router-bgp-2)# client-to-client reflection
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\