PowerProtect Data Manager 19.15 Microsoft Exchange Server User Guide

The following list describes the optional parameters you can use with msagentadmin administration commands.

--config "<configuration_file_path>"

Specifies the full path to the configuration file.

You can use the -z alias for the --config parameter.

--lockbox <lockbox_path>

Specifies the folder that contains the lockbox file, which contains encrypted information about the registered hosts and the corresponding usernames in pairs. Each pair is associated with a password that backups use.

If you do not specify a value, the path defaults to the installation path, which is typically C:\Program Files\DPSAPPS\common\lockbox.

--tier

Specifies to display the location of the save sets in either the Data Domain system (active tier) or the Data Domain Cloud Tier.

--client <client_name>

Specifies the application server hostname that contains the server instance that was backed up.

You can use the -c alias for the --client parameter.

--after <start_time>

Lists only the backups that were taken on or after the date and time, date, day, or time.

For example: 3/31/2016 15:00:00 or Tuesday.

You can use the -b alias for the --after parameter.

--debug <level_1_through_9>

Specifies the debug level for listing backups. The default value is 0 (zero).

You can use the -D alias for the --debug parameter.

--deleteDebugLog <days>

Deletes debug log files that are older than the specified number of days. The valid range is between 1 and 32767.

By default, debug logs are not deleted. Regularly deleting debug logs prevents the log folder on the installation drive from becoming too large.

This parameter only deletes debug logs named in the default format and located in the logs folder at <installation_path>\MSAPPAGENT\logs

--help

Prints a brief help message.

You can use the -h alias for the --help parameter.

--confirm

Specifies to skip the user confirmation prompts for the operation.

-a "<key-value_pair>"

Specifies the keyword and value of an option that is also specified in the configuration file. For example, -a "CLIENT=<client_name>".