- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager File System Agent Overview
- Enabling the File System Agent
- About the File System agent
- Application agent and File System agent coexistence
- File System agent prerequisites
- File System agent limitations
- Block-based backups
- Best practices for file system backups
- Configure the file system parallel backup setting
- Configure asset multi-streaming for file-based backups
- Protect an asset with the File System agent
- Protect an asset in a Microsoft Windows Server clustered environment with the File System agent
- Installing and uninstalling the File System agent on AIX
- Installing and updating the File System agent on Linux
- Installing and updating the File System agent on Windows
- Manage the File System agent
- Configure the centralized file-level restore service port number
- Update the application agent in the PowerProtect Data Manager UI
- Moving a File System agent from one PowerProtect Data Manager system to another
- Enable the File System agent after migrating File System assets to a refreshed server
- Managing Storage, Assets, and Protection
- Enable an asset source
- Discover a File System Host
- Protection policies for File System agent protection
- Supported protection policy purposes
- Supported protection policy objectives
- File System replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for file system protection
- Add a protection policy for file system protection
- Asset-level configuration for protection policies
- Protection rules
- Cancel a File System agent backup or restore job
- Add a service-level agreement
- Extended retention for protection policies
- Edit the retention period for backup copies
- Delete asset backup copies
- Host CPU throttling
- Enable the use of pre-scripts and post-scripts with backups
- File Filters
- Centralized restore of a file-system asset
- Quick recovery for server DR
- Updating the File System agent hostname or IP address
- Reregister the agent after a PowerProtect Data Manager server hostname or IP address change
- Manage the PowerProtect agent service
- Performing Self-Service Backups and Restores with the File System Agent
- Performing Self-Service Backups and Restores for Disaster Recovery
- Performing Disaster Recovery with the File System Agent in Windows
- Disaster recovery limitations
- Preparing for disaster recovery
- Performing system-state recovery
- Recovering the Active Directory
- Performing bare-metal recovery
- Perform bare-metal recovery of Windows clusters
- Disaster recovery solution for Microsoft SQL application data
- Protecting Microsoft Distributed File System using BMR and SSR
- Performing application restores after bare-metal recovery
- Deleting temporary files after bare-metal recovery
- Performing Active Directory Data Recovery at a Granular Level
- File System Best Practices and Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 File System User Guide
Uninstall the File System agent on Linux
On Linux, you can uninstall the File System agent by performing the following steps:
Steps
- Obtain the uninstall.sh script from the folder extracted from the package fsagent19x_linux_x86_64.tar.gz or under /opt/dpsapps/fsagent/bin.
-
Run
./uninstall.sh.
The following message appears:
Other application agents might be using powerprotect-agentsvc. Do you wish to uninstall powerprotect-agentsvc? [y/n]
-
Type
Y to confirm that you want to uninstall
powerprotect-agentsvc.
NOTE:If you type N, the RPM files (ppdm_bbbwt.rpm and ppdm_fsagent.rpm) and DEB files (ppdm-bbbwt.deb and ppdm-fsagent.deb) are uninstalled. However, powerprotect-agentsvc remains in an installed state.
There is no silent uninstall procedure on Linux.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\