Dell Latitude E7270 Owner's Manual

PDF

Installing the display panel

  1. To install the display panel for non touch systems:
    1. Connect the eDP cable to the connector on the back of the display panel and fix the adhesive tape.
    2. Align the display panel with the tabs on the display assembly.
    3. Tighten the screws to secure the display panel to the display assembly.
  2. To install the display panel for touch systems:
    1. Place the display panel facedown.
    2. Place the display assembly over the display panel and slide it forward.
    3. Connect the eDP cable to the connector on the back of the display panel and fix the adhesive tape.
    4. Turn the display assembly over.
    5. Align the display panel with the tabs on the display assembly.
    6. Press the edges of the display panel to secure it to the display assembly.
  3. Install the:
    1. display bezel

      • NOTE: This is applicable only for non touch systems.
    2. display assembly

    3. battery

    4. base cover

  4. Follow the procedure in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\