Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge M630 Owner's Manual

Installing the hard drive or SSD cage

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the hard drive or SSD cage to replace a faulty hard drive or SSD cage or service other components inside the system.
  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #1 screwdriver ready.

  3. Remove the hard drive or SSD cage.

Steps

  1. Align the screw holes on the hard drive or SSD cage with the screw holes on the chassis.
  2. Lower the hard drive or SSD cage into the chassis until it is seated firmly in place.
  3. Install the four screws to secure the hard drive or SSD cage to the chassis.
    Figure 1. Installing a hard drive or SSD cage
    This figure shows installing a hard drive or SSD cage.
    1. standoff (4)
    2. hard drive or SSD cage
    3. screw (2)
    4. screw hole (2)

Next steps

  1. Install the hard drive or SSD backplane.

  2. Install the hard drive or SSDs.

  3. Follow the procedure listed in the After working inside your system section.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\