Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge M630 Owner's Manual

Installing the Network Daughter Card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the NDC to replace a faulty NDC card or service other components inside the system.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Remove the mezzanine card.

  4. Remove the NDC.

Steps

  1. Align the following:
    1. The slots on the card edge with the projection tabs on the plastic bracket covering the mezzanine card slots.
    2. Screw holes on the card with the standoffs on the system board.
  2. Lower the card into place until the card connector fits into the corresponding connector on the system board.
  3. Secure the card with the two screws.
    Figure 1. Installing the Network Daughter Card
    This image shows Installing the Network Daughter Card
    1. slot on the NDC
    2. screw (2)
    3. NDC
    4. standoff (2)
    5. connector
    6. tab projections

Next steps

  1. Install the mezzanine card.

  2. Follow the procedure listed in the After working inside your system section.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\