- Notes, cautions, and warnings
- Dell PowerEdge M630 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- Boot Settings
- Network Settings
- System Security
- System Information
- Memory Settings
- Processor Settings
- SATA Settings
- Integrated Devices
- Serial Communication
- System Profile Settings
- Miscellaneous Settings
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing blade components
- Safety instructions
- Recommended tools
- Removing and installing a blade
- System cover
- Inside the blade
- Cooling shroud
- Processor blank and DIMM blank
- System memory
- I/O module mezzanine cards
- Internal dual SD module (optional)
- rSPI card (optional)
- SD vFlash card
- Network Daughter Card
- Processors
- Hard drives or SSDs
- Hard drive or SSD bay numbering
- Hard drive or SSD installation guidelines
- Removing a hard drive or SSD
- Installing a hard drive or SSD
- Removing a hard drive or SSD blank
- Installing a hard drive or SSD blank
- Shutdown procedure for servicing a hard drive or SSD
- Configuring the boot drive
- Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive or SSD carrier
- Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier
- Removing a 1.8-inch SSD from a 1.8-inch SSD carrier
- Installing a 1.8-inch SSD in a 1.8-inch SSD carrier
- Removing the hard drive or SSD cage
- Installing the hard drive or SSD cage
- Hard drive or SSD backplane
- System board
- Trusted Platform Module
- System battery
- Storage controller card or PCIe extender card
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Getting help
Dell PowerEdge M630 Owner's Manual
Shutdown procedure for servicing a hard drive or SSD
NOTE: This section applies
only to situations where the blade must be turned off to service a
hard drive or SSD. In many situations, the hard drive or SSD can be
serviced while the blade is turned on.
CAUTION: If you
need to power off the blade to service a hard drive or SSD, wait 30
seconds after the blade’s power indicator turns off before removing
the hard drive or SSD. Otherwise, the hard drive or SSD may not be
recognized after it is reinstalled and the blade is turned on again.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\