Complete the following steps to set up your system:
Steps
Unpack the blade.
Remove the I/O connector cover from the blade connectors.
CAUTION: While installing the blade, ensure that it
is properly aligned with the slot on the enclosure to prevent damage
to the blade connectors.
Install the blade in the enclosure.
Turn on the enclosure.
NOTE: Wait for the chassis to initialize before you press the power button.
Turn on the blade by pressing the
power button on the blade.
Alternatively, you can also turn on the blade by using:
The blade iDRAC. For more
information, see the Log in to iDRAC section.
The enclosure Chassis Management
Controller (CMC), after the blade iDRAC is configured
on the CMC. For more information, see the CMC User’s Guide at Dell.com/idracmanuals.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\