CAUTION: Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: Before performing the
following procedure, ensure that you have installed the memory modules
according to the memory installation guidelines for the blade.
Steps
Restart the blade:
Press the power button after to turn off
the blade.
Press the power button again to apply power
to the blade.
If no error messages appear, go to step 8.
Enter the System Setup and check the system
memory setting.
If the amount of memory installed matches the system
memory setting, go to step 8.
Remove the blade from the enclosure.
Open the blade.
CAUTION: The memory modules are hot to touch for some time after
the blade has been powered down. Allow time for the memory modules to cool
before handling them. Handle the memory modules by the card edges
and avoid touching the components.
Reseat the memory modules in their sockets.
Close the blade.
Install the blade in the enclosure.
Run the appropriate diagnostic test. For more
information, see the Using system diagnostics section.
If the test fails, see the Getting help section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\