Remote connection is used to corelate the cluster address of the remote array along with the File control network of the current array. Once remote connection is established between both the arrays, the connection status shows as “UP” which means the replication sessions can be created further.
Once the File Control Network is established on both the sites follow the below steps to establish Remote Connection:
Select
Data Protection.
Select
File Protection
.
Click
REPLICATION tab.
Click
REMOTE CONNECTION tab.
Click
Create.
Continue to work through the
Create Remote Connection wizard
Option
Description
Create Remote Connection Wizard
Enter a Name
Enter the Remote Cluster IP Address
Select a File Control Network
Click on
Run Now.
A Remote Connection is now Established.
Figure 1. Remote Connection TabFigure 2. Create Remote Connection
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
