- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3660 Tower
- Side cover
- Front bezel
- 3.5-inch hard-drive assembly
- Removing the 3.5-inch hard-disk drive assembly (Bay-1)
- Removing the 3.5-inch hard-disk drive assembly (Bay-2)
- Removing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive assembly (Bay-2)
- Installing the 3.5-inch hard-disk drive assembly (Bay-1)
- Solid state drive
- WLAN card
- Coin-cell battery
- Memory module
- GPU end holder
- Expansion card
- Processor fan and heat-sink assembly
- Power-supply unit
- Liquid cooler
- Processor
- Voltage-regulator heat sink
- Chassis fan
- Power button
- Intrusion switch
- Internal speaker
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Precision 3660 Tower Service Manual
Installing the powered GPU
Prerequisites
About this task
The following images indicate the location of the powered graphical processing unit and provide a visual representation of the installation procedure.
Steps
- Lift the pull tab to open the PCIe door.
- Align the powered GPU with the PCI-Express card connector on the system board.
- Using the alignment post, connect the powered GPU in the connector and press down firmly. Ensure that the powered GPU is firmly seated.
- Close the PCIe door.
- Slide the release latch on the graphics card holder and insert it into the slot until it clicks to place.
- Connect the two power cables, to the connectors on the powered GPU and power supply unit.
Next steps
- Install the GPU end holder.
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\