- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3660 Tower
- Side cover
- Front bezel
- 3.5-inch hard-drive assembly
- Removing the 3.5-inch hard-disk drive assembly (Bay-1)
- Removing the 3.5-inch hard-disk drive assembly (Bay-2)
- Removing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive bracket
- Installing the 3.5-inch hard-disk drive assembly (Bay-2)
- Installing the 3.5-inch hard-disk drive assembly (Bay-1)
- Solid state drive
- WLAN card
- Coin-cell battery
- Memory module
- GPU end holder
- Expansion card
- Processor fan and heat-sink assembly
- Power-supply unit
- Liquid cooler
- Processor
- Voltage-regulator heat sink
- Chassis fan
- Power button
- Intrusion switch
- Internal speaker
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Precision 3660 Tower Service Manual
Removing the intrusion switch
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the side cover.
About this task
The following images indicate the location of the intrusion switch and provides a visual representation of the removal procedure.
Steps
- Disconnect the intruder cable from the connector on the system board and unroute the cable from the routing guide.
- Slide and remove the intrusion switch from the chassis.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\