- Notes, cautions, and warnings
- Preface
- Introduction to TimeFinder SnapVX
- Performing TimeFinder SnapVX Operations
- Establish SnapVX snapshot
- Rename SnapVX snapshot
- Set SnapVX snapshot time to live (TTL)
- Set persistent SnapVX snapshot
- Convert SnapVX snapshot to secure snapshot
- Link a SnapVX snapshot
- Change SnapVX snapshot link mode
- Unlink SnapVX snapshot
- Relink SnapVX snapshot
- Restore SnapVX snapshot
- Terminate SnapVX snapshot
- TimeFinder SnapVX snapshot reporting
- TimeFinder SnapVX Configurations and Examples
- TimeFinder SnapVX State Reference Rules
- Determine SnapVX states/SRDF and ORS operations interaction
- State rules for TimeFinder SnapVX operations with SRDF pair states
- TimeFinder SnapVX operations with ORS pair states
- State rules for source control operations with SnapVX and Clone source states
- State rules for source control operations with SnapVX and Clone source states
Dell Solutions Enabler 10.0.0 TimeFinder SnapVX CLI User Guide
Change SnapVX snapshot link mode
NOTE:An expired secure or regular snapshot cannot be set to copy mode.
- set mode <copy | nocopy>
- Sets the mode of an existing link. Copy mode creates a full-volume copy of the data by copying it to the target device's SRP. Once the link is removed, both modes retain the point-in-time data.
NOTE:
- The set mode <copy | nocopy> operation is blocked on arrays running PowerMaxOS 10 (6079) and higher.
- link nocopy is not supported on arrays running PowerMaxOS 10 (6079) and higher. The actual copy is done only if src and tgt devs are in different SRPs.
Examples
To set the link mode to NoCopy for generation 5 of the 600am snapshot, enter:
symsnapvx -sid 001 -sg StorageGroup1 -snapshot_name 600am -gen 5 set mode nocopy
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\