- Notes, cautions, and warnings
- Preface
- Introduction to TimeFinder SnapVX
- Performing TimeFinder SnapVX Operations
- Establish SnapVX snapshot
- Rename SnapVX snapshot
- Set SnapVX snapshot time to live (TTL)
- Set persistent SnapVX snapshot
- Convert SnapVX snapshot to secure snapshot
- Link a SnapVX snapshot
- Change SnapVX snapshot link mode
- Unlink SnapVX snapshot
- Relink SnapVX snapshot
- Restore SnapVX snapshot
- Terminate SnapVX snapshot
- TimeFinder SnapVX snapshot reporting
- TimeFinder SnapVX Configurations and Examples
- TimeFinder SnapVX State Reference Rules
- Determine SnapVX states/SRDF and ORS operations interaction
- State rules for TimeFinder SnapVX operations with SRDF pair states
- TimeFinder SnapVX operations with ORS pair states
- State rules for source control operations with SnapVX and Clone source states
- State rules for source control operations with SnapVX and Clone source states
Dell Solutions Enabler 10.0.0 TimeFinder SnapVX CLI User Guide
SnapVX behavior when adding source devices
Over time, an application may grow (or shrink) the number of devices that it uses. SnapVX automatically adjusts restore, link, and relink operations to accommodate extra or missing snapshot names and generations.
The figure below shows a storage group with three source devices. Source device 3 is added to the storage group after the first snapshot (Mon 12pm) was established, so that snapshot does not exist for that device.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\