Terminating a snapshot removes the it from the system. To terminate a snapshot it must have no linked devices or restore sessions. To unlink a snapshot refer to
Unlink SnapVX snapshot.
Forces the operation to execute when normally it is rejected.
-keep_count
Specifies the number of most recent snapshots to be kept when terminating snapshots. This option must be used along with the
-force option. This option can only be used for automated policy snapshots only.
-older_than
Specifies all the policy snapshots with the SnapsetID lower (older) than the specified SnapsetID. This option must be used along with the
-force option. This option can only be used for automated policy snapshots only.
-snapid
Executes a terminate command using the snapsetID instead of relative generation generation number on the source SG.
-all
Terminates all snapshots on the devices for the given snapshot name.
-force
Attempts to force the operation even though one or more devices may not be in the normal, expected state(s) for the specified operation. This is required for bulk terminating snapshots.
-snapshot_name
Specifies the snapshot name to be terminated
Examples
To terminate generation
5 of the
600am snapshot, enter: