- Notes, cautions, and warnings
- Preface
- Introduction to TimeFinder SnapVX
- Performing TimeFinder SnapVX Operations
- Establish SnapVX snapshot
- Rename SnapVX snapshot
- Set SnapVX snapshot time to live (TTL)
- Set persistent SnapVX snapshot
- Convert SnapVX snapshot to secure snapshot
- Link a SnapVX snapshot
- Change SnapVX snapshot link mode
- Unlink SnapVX snapshot
- Relink SnapVX snapshot
- Restore SnapVX snapshot
- Terminate SnapVX snapshot
- TimeFinder SnapVX snapshot reporting
- TimeFinder SnapVX Configurations and Examples
- TimeFinder SnapVX State Reference Rules
- Determine SnapVX states/SRDF and ORS operations interaction
- State rules for TimeFinder SnapVX operations with SRDF pair states
- TimeFinder SnapVX operations with ORS pair states
- State rules for source control operations with SnapVX and Clone source states
- State rules for source control operations with SnapVX and Clone source states
Dell Solutions Enabler 10.0.0 TimeFinder SnapVX CLI User Guide
SnapVX snapshot link operations when adding source devices
As shown in the figure below, if target devices are linked to the Mon 12pm snapshot, target device 1 and target device 2 are linked to the snapshot, but target device 3 is marked NR because there is no data on that target for that point-in-time.
NOTE: The link command can only be used when there are no links to any of the targets. If linking in Copy mode, the result is a full copy.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\